home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Chip 1996 November
/
CHIP Kasım 1996.iso
/
win95prg
/
eudora
/
common.z
/
DEFAULT.MOD
< prev
next >
Wrap
Text File
|
1995-12-14
|
2KB
|
66 lines
;Default:Hayes (unreliable transfers)
;
; If you make a change to this file you should change the description (the
; top line) so that the setup program can distinguish this new setup from
; the one you changed. Be sure to rename and copy the modified file to
; the scripts directory.
;
; An explicit \r must be placed at the end of a send line if you wish to
; terminate the line. \r\n are stripped to \r. \n will be sent without
; translation.
;
; Remove this line if you are modifying this file and are using a modem
; which has a line speed higher than 2400 baud.
set BaudRate=2400
;
cancelon ERROR
;
send AT\r
pause 1
;
; Configuration for a generic Hayes modem
; &F - Restore factory defaults
; V1 - Verbose responses
; X4 - Most verbose/informative responses (for a typical modem)
; &C1 - Raise DCD only when carrier is present
; S7=60 - modem hangs up after 60 seconds if carrier is not established
;
send AT &FV1X4&C1&D2S7=60\r
waitfor OK
;
; A detailed discussion of how to setup a modem configuration file can be
; found in Appendix E of the Eudora manual.
;
; 1. Enter the command that configures your modem to respond to DTR.
;
; EXAMPLE: send AT &D2\r
;
;
; 2. Enter the command that configures your modem for reliable operation
; (MNP4 or V.42).
;
; EXAMPLE: send AT \\N2\r
;
;
; 3. Enter the command that supports hardware flow control (strongly
; recommended.
;
; EXAMPLE: send AT *FL\r
;
;
; 4. If you have set your modem to support hardware flow control (as
; described in step 3), change the following command that sets the
; Eudora FlowControl variable to Hardware. This command overrides
; the FlowControl value in the [Dialup] section of the EUDORA.INI
; file (this feature is only available in version 2.0.2 or later).
; This setting must match step 3 or you will lose data and corrupt
; mail messages.
;
set FlowControl=Software
; set FlowControl=Hardware
;
; 5. Enter the command that fixes (freezes) the modem baud rate.
;
; EXAMPLE: send AT \\J0\r
;